Textile Sk
-
Upload
rajesh-dwivedi -
Category
Documents
-
view
217 -
download
0
Transcript of Textile Sk
-
7/31/2019 Textile Sk
1/8
-
7/31/2019 Textile Sk
2/8
A Paper on:
Presented By
Author1: Author2:
Miss. Komal S. Patil Miss. Shweta R. Gawai
(textile 2nd year) (textile 2nd year)
-
7/31/2019 Textile Sk
3/8
Necessity is mother of all inventions.
When conventional production processesfailed in manufacturing of product in given
time with given finish and accuracy then
manufacturer think of the alternative method
in which all process of product i.e. designing ,
analysis, actual manufacturing with higher
accuracy, then making changes if any and
this is use of softwares in manufacturing.These softwares falls under CAD/CAM.
-
7/31/2019 Textile Sk
4/8
WHAT IS CAD/CAM ?
CAD is the process of creation of digital product
information.
CAM is the process of simulating the productbehavior digitally
-
7/31/2019 Textile Sk
5/8
USE OF CAD/CAM INPRODUCT DEVELOPMENT
SOFTWARE:
Computer hardware is the equipment that can be
observed.
Textile could include equipment such as monitor, hard-drive, keyboard and mouse
HARDWARE:
Software programs are written to perform certain task.
Software program such as coral-draw can be used fordesigning in graphic designing as well as fashiondesigning.
-
7/31/2019 Textile Sk
6/8
ADVANTAGES:
The productivity is improved.
Design flexibility.Product design can be easily changed.
Production time is reduced and hence theprofit is increased.
Manufacture and other people can view theproduct, analysis it before its actualproduction.
The amount of work does not vary with thecomplexity or length of the performance to thesame degree when using treditionaltechniques
-
7/31/2019 Textile Sk
7/8
DISADVANTAGES:
Specific hardware and special programs are
required to obtain and process the dataThe cost of the software and equipment,
personnel required can be prohibitive for
small production.
The capture system may have specific
requirements for the space it is operated in.
When problems occur , it is sometime
easier to reshoot the scene rather than tryingto manipulate the data. Only a few system
allow real time viewing of the data to decide if
the take needs to be redone.
-
7/31/2019 Textile Sk
8/8
CONCLUSION:
The developments in industry often surpass the
developments in training methods. That has becomethe present situation in textile industry and training fortextile industry.
Not only is the staff in the two relevant departments
concern about the current CAD training situation.Possible recommendation to change current CADtraining in the department of fashion design andtechnology and textile design have been discussed
Recommendation, such as the development of a CAD
center, are long term recommendation that wouldrequire financial investment
Development such as the development of CADcurricula, could be implemented immediately.