SS 531 Whitley Mk.V S.A. - Eduard · PDF filess531 whitley mk.v s.a. original kit parts...
Transcript of SS 531 Whitley Mk.V S.A. - Eduard · PDF filess531 whitley mk.v s.a. original kit parts...
10°
35
33
36
2
5D35
22C08
26
35
SS531
Whitley Mk.V S.A.
ORIGINAL KIT PARTSPŮVODNÍ DÍLY STAVEBNICE
PHOTO-ETCHED PARTSLEPTANÉ DÍLY
PARTS TO BE REMOVEDDÍLY K ODSTRANĚNÍ
FILLTMELIT
eduard
REMOVEODSTRANIT
OPTIONVOLBA?REPLACENAHRADIT
BENDOHNOUT
GRINDOBROUSIT
SYMETRICAL ASSEMBLYSYMETRICKÁ MONTÁŽ
DRILL HOLEVRTAT OTVOR
APPLY EXPRESS MASK AND PAINT BEFORE GLUINGPOUŽÍT EXPRESS MASK NABARVIT PRED SLEPENÍM
1 COLORED ETCHED PARTSLEPTANÉ BAREVNÉ DÍLY
1 ETCHED PARTSLEPTANÉ NEBAREVNÉ DÍLY
1 ORIGINAL KIT PARTSPŮVODNÍ DÍLY STAVEBNICE
1/3 SS 531
detail set for 1/72 AIRFIX No. A08016kit • sada detailů pro stavebnici 1/72 AIRFIX No. A08016
15
14
13
12
D37
12
14
D36+C07
16
17
D45
7
8
A04
34 21
32
31
29
1
311
2 pcs 18 19
27
STEP 1
180°
D51
23
6
STEP 2
28
24
25
16
D53
17
4
9 10
30
2 pcs
A05
2/3 SS 531
20
Made in Czech RepublicEduard M.A. © 2015 www.eduard.com
3/3 SS 531
PARTS WITH GLUE DÍLY OPATŘENÉ LEPIDLEM
2. Do not inadvertently place etched componets on an unwanted surface. Attempts to remove will result in damage to your part.
2. Nepokládejte samolepící díly na volné plochy. Pokud je omylem přilepíte, při pokusu o odlepení dojde k poškození dílu.
3. Do not touch the adhesive areas of the etched components.
3. Nesahejte na části dílů, na kterých je naneseno lepidlo.1. Separate the etched components from their frames on the protective paper. Removal from the paper is done only after separation of the parts from the frames.
1.Samolepící díly oddělujte od rámečku na podkladovém papíře. Po oddělení je sejměte z krycího papíru.
4. Hold the parts by the edges, or at areas free of adhesive.
4. Samolepící díly berte za hrany nebo za části, na kterých není nanesené lepidlo.
5. Lightly place the component in the desired location and position. Adjust as required. The component will be permanently affixed when pressed onto its intended location, its location can be adjusted.
5. Díl lehce položte do pozice, ve které má být nalepen. Upravte přesnou pozici a přimáčkněte. Díl dokonale přilne až po přimáčknutí, před přimáčknutím lze dílem opatrně manipulovat.