Key Points Revision:Role of furnish.
Diminishing gains of dryness with increase in vacuum.
Diminishing gains of dryness with increase in dwell time.
Web dryness as a function of basis weight.
Air Flow Increases With:Increase in vacuum
Increase in open area or dwell time.
Increase in web dryness.
General Thumb Rules:In the suction boxes of wire part, the
vacuum must be in increasing order.More vacuum: higher drynessMore dwell time: higher dryness
Can I Reduce Energy Required for Vacuum?
Dryness achieved (x) and energy required (y) follow a pattern like this graph. (Please omit the values)
Strategies:Apply vacuum in increasing order.Last suction box operates at
maximum vacuum.Reduction of its open area reduces
air flow requirements, hence vacuum power consumption will reduce.
Strategies:We generally apply less than 7”
vacuum.For such a lower level, water ring
vacuum pump is not really required.Consider twin/three lobe blower or
similar equipment.
In-Plant Experimentation:Start with vacuum in increasing order.Typical values could be-
Check dryness after last box versus peak vacuum, and the effect of peak vacuum in last box on dryness.
Reduction Factor
Box 6 Box 5 Box 4 Box 3 Box 2 Box 1
60% 150 90 54 32 19 11mmHg
70% 150 105 73 51 35 24mmHg
Effect of Peak Vacuum:Quite possibly, you may get a peak
vacuum level after which increase in dryness is almost negligible.
Initially, the same exercise may be done by throttling the valves.
Consider using a VFD to get desired peak vacuum.
Effect of Peak Vacuum:Remember-
◦Reduction of peak vacuum will also help in getting increased wire life.
◦Furthermore, drag load on wire will also decrease in addition to the possibility of energy saving in vacuum pump.
Dwell Time:For most furnishes and basis weight
range of 50-100gsm, 10-15ms is sufficient.
Many mills operate at 50-150ms.Bagalley Box normally works at 2-
3ms.A couple of graphs on coming slides
indicate effect of dwell time.
Effect of Dwell Time
For 48gsm newsprint
Effect of Dwell Time
127gsm (experimental data)
Dwell Time:As clear from earlier graphs-
Even a single slot suitable for 15-20ms can increase web solids from 5-6% to practically maximum achievable.
Multiple slots, with increasing vacuum help maintain fiber network with lesser open area in higher vacuum zone.
Roots Blower:Many mills have installed roots
blower and are saving energy.Some faced problems of pulsation
and hammering. Proper layout and piping design is a must to get results from roots blower.
Typical Savings:In a small paper mill (40 TPD), wire part
vacuum was reduced from 72m3/min(110kW motor) to just 28m3/min(55kW motor) after dwell time was reduced from 150ms to 100ms.
A significant improvement in wire life (nearly double) was observed after modification.
Further reduction in dwell time is under planning.
How to Achieve this?Just check your table, and
calculate total open area. Find out total dwell time. Explore
possibilities to reduce if it is too high, by shutting vacuum in one or two boxes.
Recheck web dryness after the same. If everything is fine, replace boxes with lesser open area ones.
Or, discuss with some expert.
Conclusion:There exists tremendous scope for
energy conservation in paper machine wire part.
Proper designing of wire table and optimization of vacuum play important role in energy conservation and wire life improvement.
THANK YOU
Top Related