8/12/2019 Lexmark C510 Reman Eng
http://slidepdf.com/reader/full/lexmark-c510-reman-eng 1/5
8/12/2019 Lexmark C510 Reman Eng
http://slidepdf.com/reader/full/lexmark-c510-reman-eng 2/5
8/12/2019 Lexmark C510 Reman Eng
http://slidepdf.com/reader/full/lexmark-c510-reman-eng 3/5
REQUIRED TOOLS
1. Toner approved vacuum
2. Phillips head screwdriver
3. Small jewelers Phillips screwdriver
4. Soft lint-free wipes
REQUIRED SUPPLIES
1. Toner for Lexmark C510 (310g black, 210g color)
2. Developer roller cover
1. Remove the two silver screws from the outer edge of the
doctor blade.
2. Lift up on the doctor blade side and remove the developer
roller assembly.
3. Dump out all remaining toner from the chamber. The fill plug
in these cartridges is not removable. Blow out any remaining
toner from the hopper paying special attention to the feed
roller. It can become clogged (impacted) with toner and ovetime this will interfere with the amount of toner fed to the
developer roller
LEXMARK C510 TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]
www.uninet imaging.com
8/12/2019 Lexmark C510 Reman Eng
http://slidepdf.com/reader/full/lexmark-c510-reman-eng 4/5
4. Make sure the gears on both sides of the cartridge are clean and turn freely.
5. It is best not to take the doctor blade assembly apart, but if
you do, use a gapping gauge to measure the gap by each of
the five screws before removing any of them. Set the gap back
to the proper distance when re-assembling the bladeassembly.
6. Fill the hopper with the appropriate color toner. While the
cartridges all look the same, they are not interchangeable
Each color has a different set of plastic tabs.
LEXMARK C510 TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]
www.uninet imaging.com
8/12/2019 Lexmark C510 Reman Eng
http://slidepdf.com/reader/full/lexmark-c510-reman-eng 5/5
7. Install the developer roller assembly small gear to the fill plug side of the cartridge.
Install the outer screws. NOTE: Make sure the black tab is facing forward (as shown).
8. Install the developer roller cover.
LEXMARK C510 TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]
www.uninet imaging.com
Top Related