Week 11 AutoCAD
-
Upload
ana-silvia-hernandez -
Category
Documents
-
view
228 -
download
1
description
Transcript of Week 11 AutoCAD
Ana Silvia Hernandez Balcazar 3/12/12
ACAD WEEK 11 Isometric and Axonometric Drawings: Let’s assume you have an object, and you want to make an elevation of it in axonometric and isometric view. Let’s start with the isometric. Isometric:
This is the image you want to make an elevation drawing from.
Now select your image.
Ana Silvia Hernandez Balcazar 3/12/12
1) Now, once you have selected your image, you will type the shortcut “RO” on your keyboard, which is the option to rotate your object. 2) Once you’ve done that now you select the point from where you want to rotate. 3) The move your cursor to the way you want to rotate it and type 30, or -‐30, depending on which one works for you, but remember it has to be at 30 degrees for the object to be isometric.
Do straight vertical lines from each corner. Remember all of them have to be the same height, in this case
400 mm.
1
3
2
Ana Silvia Hernandez Balcazar 3/12/12
Now connect the points so have an object like this.
To finish it, all you have to do is use the “trim tool” so you can get rid of all those lines you don’t want and have a final
object like this.
Ana Silvia Hernandez Balcazar 3/12/12
1) Now, once you have selected your image, you will type the shortcut “RO” on your keyboard, which is the option to rotate your object. 2) Once you’ve done that now you select the point from where you want to rotate. 3) The move your cursor to the way you want to rotate it and type 45, or -‐45, depending on which one works for you, but remember it has to be at 30 degrees for the object to be axonometric.
Axonometric:
Now select your image.
1 2
3
Ana Silvia Hernandez Balcazar 3/12/12
Do straight vertical lines from each corner. Remember all of them have to be the same height, in this case
400 mm.
Now connect the points so have an object like this.
To finish it, all you have to do is use the “trim tool” so you can get rid of all those lines you don’t want and have a final
object like this.