Electrical deep-well cargo...
Transcript of Electrical deep-well cargo...
-
Electrical deep-well cargo pumps
Pres-Vac Engineering ApS
로Martin Skytte, 사업단위관리자
-
PRES-VAC ENGINEERING APS
• Cargo pumps
– Capacity: 100-400 m3/h
– Head: 100-125 mWg
• Ballast pumps
– Capacity: 600-1.200 m3/h
– Head: 25-50 mWg
• Emergency pumps
– Capacity: 70 m3/h
– Head: 70 mWg
Pres-Vac offering
-
PRES-VAC ENGINEERING APS
Pump type Sold
EL-CHEM 150-2/315 48
EL-CHEM 100-3/315 29
EL-CHEM 200-2/400 36
EL-CHEM 100-2/315 24
EL-CHEM 150-1/408 92
EL-GAS 100-3/315 4
EL-GAS 100-4/315 3
Cargo pumps total 236
Ballast pumps 28
Emergency pumps 10
Installed base – cargo pumps
• 150-2/315 = DN Flange diameter (150) - number of stages (2)/impeller diameter (315)
• First pump produced in 2000
EL-C
HEM
15
0-1
/40
8
EL-C
HEM
15
0-2
/31
5
-
PRES-VAC ENGINEERING APS
• Electrical cargo pumps
– Are more energy efficient (17%)
– Require less space (50%)
– Weighs less (25%)
– Is less noisy than traditional hydraulic pumps
– Requires less maintenance
– Has 35 - 42% lower initial cost
– 38 - 55% lower annual operating cost
Why electrical pumps?
Information is taken from Delta Marin Report 19.04.2007
-
PRES-VAC ENGINEERING APS
Pump unit
• Design principles– Easy to use
– Durable
– Few wear parts
– Less maintenance
– Easy to repair
– Computer controlled
– Build in safety measures in control program
Check lift
Thrust bearing
Impeller
Radial bearing
Magnetic coupling
Motor shaft
Bearing
Wear indicator
Lubrication pipe
-
PRES-VAC ENGINEERING APS
Single stage Cargo pump
• Separation of lubrication oil and cargo
– Protection of cargo from leakage
– Eliminates purge operation
– Low wear cost
-
PRES-VAC ENGINEERING APS
Single stage Cargo pump
• Magnetic drive
– No mechanical seal
– Reduced Maintenance cost
– Enable quick exchange of pump unit
– Large temperature operating range
-
PRES-VAC ENGINEERING APS
• Cargo lubricated bearings
– Top and bottom bearing
– High pressure cargo from discharge pipe
– Cargo is filtered before it is used as lubrication
Single stage Cargo pump
-
PRES-VAC ENGINEERING APS
• Bottom valve
– Self closing
– Prevents return flow at the end of discharging
• Side valve
– Ensure minimum residue in pump well
– Less than 5 liter (below IMO requirements)
Single stage cargo pump
-
PRES-VAC ENGINEERING APS
Secondary foot valve - testVideo clip: View in Slide show mode
-
PRES-VAC ENGINEERING APS
Control system features
• Intuitive and easy to handle
• Pump control optimization and safety– Auto Slow Down at low load to prevent dry running
• Connection to external sensors
• Cargo data management integration
• Error reporting
• Service intervals and parts guidance
• Language support
• Extensive documentation
• Roughed PLC controlled hardware
-
PRES-VAC ENGINEERING APS
Designed for plug and play service
• Pumps is designed for plug and play exchange
• Pump unit can be exchanged without draining lubrication oil
• Pump unit can be exchanged within 30 min.
• No use of special tools to exchange pump unit
• No overhaul of pump unit on vessel necessary
-
PRES-VAC ENGINEERING APS
Feature DescriptionProduct range • Cargo pumps: 100 to 400 m3/h
• Ballast and emergency pumpsTechnology • Electrically driven
• PLC controlled• Magnetic coupling
Safety • Bearing alarm to monitor inside pump• Dry running protection in software
Ease of operating • Bottom valve preventing return flow• Secondary foot valve• Super stripping
Usability • Integration to Cargo Monitoring Systems• Pre-set cargo types• Load balance and pump grouping• Service intervals and spare parts• Language support• Error reporting
Operational • Service available 24/7• Designed for plug and play service• Simple and efficient service check routines
Feature summary