Biofeedback Scan Tips
-
Upload
spooky2-rife -
Category
Health & Medicine
-
view
19 -
download
0
Transcript of Biofeedback Scan Tips
Spooky2
Our Users & Team
Biofeedback Scan Tips
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:[email protected] [email protected]
Below are some biofeedback scan tips for your reference:
‣ To scan reliably, make sure you're properly hydrated, and that you've attended to bathroom
needs before you start.
‣ To detect heart rate changes due solely to frequency hits, you need to be relaxed. Meditation,
breathing exercises, peaceful music, or even just zoning out for five minutes works.
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:[email protected] [email protected]
‣ Or you can use a web white noise generator and leave it running in the background. We
recommend this website.
‣ Ideally, you should be lying down flat on a comfortable surface, with your head supported by a
pillow. You should also be comfortably warm. Avoid movement if possible.
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:[email protected] [email protected]
‣ You may use Remote or Contact Modes to input the frequencies. For Remote Mode, use a Bio
North model and a fresh DNA specimen. If using TENS pads, place one on the back of the right
hand, and the other just below the outside ankle of the left foot.
‣ A fingerclip sensor should be attached to the left hand finger that's most comfortable for you.
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:[email protected] [email protected]
‣ An earclip sensor can be attached to an earlobe. However, because earlobes are rich in
sebaceous glands, sebaceous oil may interfere in some cases. If so, you can instead attach the
clip to the left little finger, or to the fold of skin between your left thumb and index finger.
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:[email protected] [email protected]
‣ If a scan is intertupted, you must restart it from scratch. Scans cannot be paused once they've
started.
‣ You may find yourself falling asleep. This isn't a problem as long as you remember that you're
connected to the PC when you wake up (and also possibly to the generator). However, if the
Spooky Pulse clip has been dislodged and fallen off, you must repeat the scan from the
beginning.
Source: Spooky2_User's_Guide_20161021