Ashutosh ppt

14
By Ashutosh kumar Roll no. 15CE64R08 IIT kharagpur 1

Transcript of Ashutosh ppt

Page 1: Ashutosh ppt

By Ashutosh kumar

Roll no. 15CE64R08IIT kharagpur

1

Page 2: Ashutosh ppt

Earthquake resistant designsDesign - but it is analysis of forces - buildings

due to loads acting on it.

If a building is enough to resist the earthquake, then such building is called Earthquake resistant structure.

Such design is called Earthquake resistant designs

2

Page 3: Ashutosh ppt

Earthquake Resisting Structures Techniques:

3

BASE ISOLATION METHOD

ENERGY DISSIPATION DEVICE -(Seismic Dampers)

KEEPING BUILDING UP THRUST

Page 4: Ashutosh ppt

Introduction of Resistant techniques

Thought - Base Isolation Devices - separate building from ground by some rubber devices.

Seismic dampers - special devices - introduced in building - absorb the energy - produced by seismic waves.

4

Page 5: Ashutosh ppt

Base Isolation Method

5

Page 6: Ashutosh ppt

It uses bearing pads that have a curved surface and low-friction materials similar to teflon.

During an earthquake the building is free to slide both horizontally and vertically.

It will return to its original position after the ground shakeing stops.

6 6

Page 7: Ashutosh ppt

Seismic Dampers

7

Page 8: Ashutosh ppt

Dampers are of:

Viscous Damper Friction Damper Yielding Damper

Page 9: Ashutosh ppt
Page 10: Ashutosh ppt

10

Page 11: Ashutosh ppt

Keeping Building Up thrustWhen the quake

strikes the system dissipates energy in the building cores and exteriors.

The frames are free to rock up and down within fittings fixed at their bases.

11

Page 12: Ashutosh ppt

American Journal of Engineering Research volume-02. Issue-12, PP-258-268 www.ajer.org .

International Journal of Research in Engineering and technology (IMPACT: IJRET) Vol.3, Issue 12, Dec. 2015.

12

References:

Page 13: Ashutosh ppt

13

Page 14: Ashutosh ppt

THANK YOU…

14