2002 Focus CMP
3
SECTION 303-14: Electronic Engine Controls 2002 Focus Workshop !nu!l "EO#$% $N& INST$%%$TION Camshaft Position (CMP) Sensor —2.0L SPI Removal 1. Remov e the fu el in ject ion su pply manif old. For a dditi onal i nformatio n, ref er to Secti on 303-04A . For additional information, refer to Section 303-04 . For additional information, refer to Section 303-04! . ". #is connect the camshaft posit ion $! %&' se nsor elec tri cal connector. 3. Remov e t he !%& sens or . Installation 1. (o i nstall , reverse the remov al procedure.
Transcript of 2002 Focus CMP
7/23/2019 2002 Focus CMP
http://slidepdf.com/reader/full/2002-focus-cmp 1/2
SECTION 303-14: Electronic Engine Controls 2002 Focus Workshop !nu!l
"EO#$% $N& INST$%%$TION
Camshaft Position (CMP) Sensor —2.0L SPI
Removal
1. Remove the fuel injection supply manifold. For additional information, refer to Section303-04A . For additional information, refer to Section 303-04 . For additional information,refer to Section 303-04! .
". #isconnect the camshaft position $!%&' sensor electrical connector.
3. Remove the !%& sensor.
Installation
1. (o install, reverse the removal procedure.
7/23/2019 2002 Focus CMP
http://slidepdf.com/reader/full/2002-focus-cmp 2/2
SECTION 303-14: Electronic Engine Controls 2002 Focus Workshop !nu!l
"EO#$% $N& INST$%%$TION
Camshaft Position (CMP) Sensor —2.0L Zetec-E
Removal
1. Remove the air cleaner outlet pipe.
". #etach the )reather pipe.
3. #isconnect the camshaft position $!%&' sensor electrical connector.
4. Remove the !%& sensor.
Installation
1. (o install, reverse the removal procedure.
