KIP-620ML �M�A�N�U�A�L

�I�N�T�E�R�P�H�O�N�E■Magnetic Interlocking Slave Interphone

■Magnetic Paging and Calling

■Individual Voice Paging (Broadcasting)

■Button Lamp Display for Paging and Calling

www.kocom.com

KIP-620ML 11.03.23

SINCE

1976KOREA COMMUNICATIONS CO.,LTD

http://www.kocom.comE-mail : export@kocom.co.krThis manual is based on the date as shown in the right and specifications are subject tochange without notice for quality improvement

Warranty

Warranty Card

1) This product is produced under strict quality control and inspection procedures. 2) If this product breaks down during proper use as a result of product defect, KOCOM will repair it within one year from date of purchase free of charge. 3) The following cases will be subject to charge, even during warranty period: a. Breakdown during transport, or through careless treatment, by consumer. b. Breakdown cause by unauthorized repair, or system modification. c. Breakdown caused by natural disaster or power disorder.

1. Name of the product.2. Model number of the product.3. The area of problem.4. Phone number and address at which you can be contacted.

PRODUCT

MODEL

DATE PURCHASED

WARRANTY PERIOD

AGENCY ADDRESS

KOCOM Warranties the original purchaser of this product as follows.

To receive after service, have the following ready before you contact our branches.

Thank you very much for your purchasing of our product.Please read carefully before operating and then keep it. Thank you.

How to Install

Wiring Diagram

SIDEBACKFRONT

Handset

Household Paging Button(Melody)

Voice Paging Button(Broadcasting)

Groove of Table Stand

Terminal box

3-stage Volume Switch

Groove of Wall Latch

PG

Connect a connecting wire of the household and a power line to a terminal.

■ Table Type ■ Wall-mounted Type

1

Insert a table stand into the groove on the bottom of an interphone.

2

Fix a table stand by a screw. Fix the connecting wires of the terminal up (as seen in a figure) ordown by a screw.

3

Insert a handset stopper so that the rack of a handset hangs up downward.

4

1 2

3 4

■ Household Paging/ Individual Voice Paging and Calling

- To connect a wiring code to a terminal,

loose a screw, connect the end of a cord to

the bottom of the screw and then fix it.

- To fix a wiring code, fix it with a stapler not to

damage the cord.

- To use the existing wire, be careful of

disconnection and short circuit.

※ Household sub DS-2C

: Polarity (Household Wire : +, COM : -)

KIP-300 Series : non-polarity.

If the household picks up a handset or press a button [Page/Call], the call is connected.(Automatic Close for DS-2C calling time more than 90 seconds)

※ If 3 DS-2C or more are on the line at the same time, the calling sound may be not heard. Be careful.

Pick up a handset and press the button of the household.

KIP-620ML

or

KIP-300

DS-2C

Ring-back tone rings at the interphone of the household.

■ Paging from a Household

If a household picks up a handset or presses a button [Page/Call], an interphone rings ring-back tone.(The button lamp of the household is turned on.)If a household picks up a handset, a call is connected with the household. (Automatic Close for DS-2C calling time more than 90 seconds)

Product Functions

Product Composition

How to Use

Model No.

Input Power

Power Consumption

Call Mode

Wiring Specification

Size

KIP-620ML

DC 24V

FULL LOAD : 10W, ON STAND BY : 1.0W

Handset Call Mode

Terminal Mode

(W)175mmX(H)175mmX(D)55mm

Table StandInterphone

Terminal box

Wall Latch

Adapter

[Perpect power ADS-48W-24-2-2448]

The voice is transferred to the speaker of the household.

Terminal

1) Install a wall latch on 1-hole box or a wall by a screw.

2) Connect the wires in accordance with the wiring diagram

of interphones.

3) Hang up an interphone and then fix it onto a wall latch

by a screw.

4) Insert a handset stopper so that the rack of a handset

hangs up upward.

Pick up a handset and press the button of individual voice paging (broadcasting).

If a user speaks by a handset after pressing the button of the household (individual voice paging time : 20 sec.)

·Screw for fixing a Wall Latch

·Screw for fixing the monitor of a Wall Latch

Screw for fixing a Table Stand

4×25mm(4ea)

3×8mm(1ea)

2.5×5mm(2ea)

Name of Devices

또는

or

or

24Terminal box

KIP-620ML

or

Polarity

Polarity

Polarity

KIP-300

KIP-300

KIP-300

nonPolarity

or

nonPolarity

or

nonPolarity

VCCGND

COM

DS-2C

DS-2C

DS-2C

Adapter

2324

25

1617

1819

2021

2229

309

1011

1213

1415

12

34

56

78

B26C

27D2

8L

L1-

+

House 1(+)

COM(-)

House 2(+)

House 20(+)

COM(-)

COM(-)

23 24 25

16 17 18 19 20 21 22 29

309 10 11 12 13 14 15

1 2 3 4 5 6 7 8

B26 C27D28 L L1 - +A B

A:COM(-) B:power 1~20:house(+)

Terminal box