Slide 1

1 Kyung Hee University Multiplexing

Slide 2

2 6 (Multiplexing) Dividing a link into channels Word link refers to the physical path Channel refers to the portion of a link that carries a transmission between a given pair of lines.

Slide 3

3 Kyung Hee University (Multiplexing) (Multiplexing) is the set of techniques that allows the simultaneous transmission of multiple signals across a single data link.

Slide 4

4 Kyung Hee University 6.1 FDM (Multiplexer) transmission streams combine into a single stream(many to one) (Demultiplexer) stream separates into its component transmission(one to many) and directs them to their intended receiving devices

Slide 5

5 Kyung Hee University 8.2 Many to One/One to Many Categories of Multiplexing

Slide 6

6 Kyung Hee University FDM FDM(Frequency-Division Multiplexing) is an analog technique that can be applied when the bandwidth of a link is greater than the combined bandwidths of the signals to be transmitted

Slide 7

7 Kyung Hee University FDM (contd) FDM process each telephone generates a signal of a similar frequency range these signals are modulated onto different carrier frequencies(f1, f2, f3)

Slide 8

8 Kyung Hee University FDM (contd) FDM multiplexing process, time-domain

Slide 9

9 Kyung Hee University FDM(contd) FDM multiplexing process, frequency-domain

Slide 10

10 Kyung Hee University FDM(contd) Demultiplexing separates the individual signals from their carries and passes them to the waiting receivers.

Slide 11

11 Kyung Hee University FDM(contd) FDM demultiplexing process, time-domain

Slide 12

12 Kyung Hee University FDM(contd) FDM demultiplexing, frequency-domain

Slide 13

13 Kyung Hee University Example 1 Assume that a voice channel occupies a bandwidth of 4 KHz. We need to combine three voice channels into a link with a bandwidth of 12 KHz, from 20 to 32 KHz. Show the configuration using the frequency domain without the use of guard bands. Solution Shift (modulate) each of the three voice channels to a different bandwidth, as shown in Figure 6.6.

Slide 14

14 Kyung Hee University Example 1 (contd)

Slide 15

15 Kyung Hee University Example 2 Five channels, each with a 100-KHz bandwidth, are to be multiplexed together. What is the minimum bandwidth of the link if there is a need for a guard band of 10 KHz between the channels to prevent interference? Solution For five channels, we need at least four guard bands. This means that the required bandwidth is at least 5 x 100 + 4 x 10 = 540 KHz, as shown in Figure 6.7.

Slide 16

16 Kyung Hee University Example 2 (contd)

Slide 17

17 Kyung Hee University Example 3 Four data channels (digital), each transmitting at 1 Mbps, use a satellite channel of 1 MHz. Design an appropriate configuration using FDM Solution The satellite channel is analog. We divide it into four channels, each channel having a 250-KHz bandwidth. Each digital channel of 1 Mbps is modulated such that each 4 bits are modulated to 1 Hz. One solution is 16- QAM modulation. Figure 6.8 shows one possible configuration.

Slide 18

18 Kyung Hee University Example 3 (contd)

Slide 19

19 Kyung Hee University FDM(contd) Example : Cable Television coaxial cable has a bandwidth of approximately 500Mhz individual television channel require about 6Mhz of bandwidth for transmission can carry 83 channels theoretically

Slide 20

20 Kyung Hee University Analog Hierarchy To maximize the efficiency of their infrastructure, telephone companies have traditionally multiplexed signals from lower bandwidth lines onto higher bandwidth lines.

Slide 21

21 Kyung Hee University Applications of FDM Example 4 The Advanced Mobile Phone System (AMPS) uses two bands. The first band, 824 to 849 MHz, is used for sending; and 869 to 894 MHz is used for receiving. Each user has a bandwidth of 30 KHz in each direction. The 3- KHz voice is modulated using FM, creating 30 KHz of modulated signal. How many people can use their cellular phones simultaneously? Solution Each band is 25 MHz. If we divide 25 MHz into 30 KHz, we get 833.33. In reality, the band is divided into 832 channels.

Slide 22

22 Kyung Hee University 6.2 Wave Division Multiplexing (WDM) WDM is conceptually same as FDM except that the multiplexing and demultiplexing involve light signals transmitted through fiber-optic channels

Slide 23

23 Kyung Hee University WDM (contd) WDM is an analog multiplexing technique to combine optical signals. Very narrow bands of light from different sources are combined to make a wider band of light

Slide 24

24 Kyung Hee University WDM (contd) Combining and splitting of light sources are easily handled by a prism Prism bends a beam of light based on the angle of incidence and the frequency. One application is the SONET.

Slide 25

25 Kyung Hee University 6.3 TDM TDM(Time-Division Multiplexing) is a digital process that can be applied when the data rate capacity of the transmission medium is greater than the data rate required by the sending and receiving device TDM is a digital multiplexing technique to combine data.

Slide 26

26 Kyung Hee University TDM(contd)

Slide 27

27 TDM (contd) In a TDM, the data rate of the link is n times faster, and the unit duration is n times shorter.

Slide 28

28 Kyung Hee University TDM (contd) Example 5 Four 1-Kbps connections are multiplexed together. A unit is 1 bit. Find (1) the duration of 1 bit before multiplexing, (2) the transmission rate of the link, (3) the duration of a time slot, and (4) the duration of a frame? Solution We can answer the questions as follows: 1. The duration of 1 bit is 1/1 Kbps, or 0.001 s (1 ms). 2. The rate of the link is 4 Kbps. 3. The duration of each time slot 1/4 ms or 250 s. 4. The duration of a frame 1 ms.

Slide 29

29 Kyung Hee University TDM(contd) TDM can be implemented in two ways Synchronous TDM Asynchronous TDM

Slide 30

30 Kyung Hee University TDM(contd) Synchronous TDM the multiplexer allocates exactly the same time slot to each device at all times, whether or not a device has anything to transmit.

Slide 31

31 Kyung Hee University TDM(contd) Frame Time slots are grouped into frames A frame consists of one complete cycle of time slots, including one or more slots dedicated to each sending device, plus framing bits.

Slide 32

32 Kyung Hee University TDM(contd) Synchronous TDM

Slide 33

33 Kyung Hee University TDM(contd) Interleaving synchronous TDM can be compared to a very fast rotating switch switch moves from device to device at a constant rate and in a fixed order 6 empty slots out of 24 are being wasted

Slide 34

34 Kyung Hee University TDM(contd) Demultiplexer decomposes each frame by discarding the framing bits and extracting each character in turn Synchronous TDM, demultiplexing process

Slide 35

35 Kyung Hee University TDM(contd)

Slide 36

36 TDM(contd) Example 6 Four channels are multiplexed using TDM. If each channel sends 100 bytes/s and we multiplex 1 byte per channel, show the frame traveling on the link, the size of the frame, the duration of a frame, the frame rate, and the bit rate for the link. Solution

Slide 37

37 Kyung Hee University TDM(contd) Example 7 A multiplexer combines four 100-Kbps channels using a time slot of 2 bits. Show the output with four arbitrary inputs. What is the frame rate? What is the frame duration? What is the bit rate? What is the bit duration? Solution Figure 6.16 shows the output for four arbitrary inputs.

Slide 38

38 Kyung Hee University TDM(contd)

Slide 39

39 TDM(contd) Framing bits ~ allows the demultiplexer to synchronize with the incoming stream so that it can separate the time slots accurately (ex: 01010101 .)

Slide 40

40 Kyung Hee University TDM(contd) Synchronous TDM Example 4 characters + 1 framing bit

Slide 41

41 Kyung Hee University TDM(contd) Asynchronous TDM : statistical time-division multiplexing Synchronous or Asynchronous : Not flexible or Flexible

Slide 42

42 Kyung Hee University TDM(contd) Examples of asynchronous TDM frames a. Case 1: Only three lines sending data

Slide 43

43 Kyung Hee University TDM(contd) b. Case 2: Only four lines sending data

Slide 44

44 Kyung Hee University TDM(contd) c. Case 3: All five lines sending data

Slide 45

45 Kyung Hee University Multiplexing application(contd) Analog Hierarchy To maximize the efficiency of their infrastructure, telephone companies have traditionally multiplexed signals from lower bandwidth lines onto higher bandwidth lines.

Slide 46

46 Kyung Hee University Multiplexing application(contd) Digital Services advantage - less sensitive than analog service to noise - lower cost

Slide 47

47 Kyung Hee University Multiplexing application(contd) DS(Digital Signal) Service ~ is a hierarchy of digital signal

Slide 48

48 Kyung Hee University Multiplexing application(contd) DS Service DS-0 : single digital channel of 64Kbps DS-1 : 1,544Mbps, 24 64Kbps + 8Kbps overhead DS-2 : 6,312Mbps, 96 64Kbps+168Kbps overhead DS-3 : 44,376Mbps, 672 64Kbps+1.368Mbps overhead DS-4 : 274,176Mbps,4032 64Kbps+16.128Mbps overhead

Slide 49

49 Kyung Hee University Multiplexing application(contd) T Lines ServiceLineRate(Mbps)Voice Channels DS-1 DS-2 DS-3 DS-4 T-1 T-2 T-3 T-4 1,544 6,312 44,736 274,176 24 96 672 4032

Slide 50

50 Kyung Hee University T Lines for Analog Transmission T-1 line for multiplexing telephone lines

Slide 51

51 Kyung Hee University T-1 Frame 193 = 24 x 8 + 1(1 bit for synchronization)

Slide 52

52 Kyung Hee University E Lines E line rates E Line Rate (Mbps) Voice Channels E-1 2.048 2.048 30 30 E-2 8.448 8.448 120 120 E-3 34.368 34.368 480 480 E-4139.2641920

Slide 53

53 Kyung Hee University TDM(contd) Inverse Multiplexing takes the data stream from one high-speed line and breaks it into portion that can be sent across several lower speed lines simultaneously, with no loss in the collective data rate

Slide 54

54 Kyung Hee University TDM(contd) Multiplexing and inverse multiplexing

Slide 55

55 Kyung Hee University TDM(contd) Why do we need inverse multiplexing ? wants to send data, voice, and video each of which requires a different data rate. [example] voice - 64 Kbps link data - 128 Kbps link video - 1,544 Mbps link