1

Servo motor controller Using Arduino

PICTURE OF SERVO MOTOR

2

PRESENTED BY:-JITENDRA SUWASIYA (2013/IEE/001)AMIT KUMAR (2013/IEE/036)ANIL KUMAR (2013/IEE/042)

GUIDED BY:- Mr, Bishnu mohan Jha sir

3

Introduction to ArduinoArduino is an open-source prototyping platform

based on easy-to-use hardware & software and are able to read Inputs.

Arduino Boards has mainly 3 types of signal ports:• (i)Digital ports : means something is either on or off• (ii)Analog ports : means it can have a continuous

range of values. • (iii)Power ports : it provides the power supply.

4PICTURE FOR ARDUINO

5

Introduction to Servo Motors Control & Arduino

A servo is a motor that we can command to go to particular angle .

A servo has 3 pins: (i) Power (normally red) (ii)Ground (normally black) (iii) Signal pin (normally white)

6

Servos are given a command of what angle to be turn (between 0 deg. & 180 deg.) and turn precisely to that location.

The Arduino language has support for servos built-in which makes the servos really easy to use.

7

PARTS Of Servo MotorIt consists of a suitable motor , position sensor

and a sophisticated controller.

8

Working Principle Of Servo Motor Servo-motors are used to control position and speed very

precisely , but in a simple case , position may be controlled.Mechanical position of the shaft can be sensed by using a

potentiometer , which is coupled with the motor shaft through gears .

The current position of the shaft is converted in to electrical signal by the potentiometer , and compared with command input signal.

If the feedback signal differs from the given input, an error signal is generated.

9

This error signal is then amplified and applied as the input to the motor , which causes the motor to rotate . And when the shaft reaches to the required position , error signal become zero.

10

Advantage of servo motor controlling

Continuous duty Reversible. Speed is proportional to the applied voltage. Torque is proportional to the current. Very efficient No power required to hold a static load in position Flat speed –torque curve Peak torque available for short period of time Smooth rotation at low speeds Good up to 3,000 R.P.M.

11

Future trends in servoDue to increase of Automation and development of new

application of servo system it has a high scope in future.Due to price reduction there is a beneficial effect on

growth of servo system in future.Due to continuous technology improvement in this

electronic device it has high scope in future.The servo drives sector is benefiting from the popularity

of intelligent drives that combine drive and controller capabilities ,which leading it towards high growth .

12

Summary Servo control system reduces the error of the

system and improves the output mechanism.Due to blocking of error, the efficiency of the

device decreases.It is easier to design and implement.It can operate on both AC or DC.

13

ReferenceIntroduction to servo system : By I.A. Getting.Servo control system :By Elke Laubwald www.uotechnology.edu.inwww.toolingu.comArduino software library (Programming)

14

THANK YOU!