Post on 19-Jul-2016
description
FT095EN_B_1014_MHT1490 www.manitou.com
technical data sheet
FT095EN_B_1014_MHT1490.indd 1 21/10/14 16:33
FT095EN_B_1014_MHT1490
This brochure describes versions and configuration options for MANITOU products which may be fitted with different equipment. The equipment described in this brochure may be standard, optional or not available depending on version. MANITOU reservesthe right to change the specifications shown and described at any time and without prior warning. The manufacturer is not liable for the specifications given. For more information, contact your MANITOU dealer. Non-contractual document. Product descriptionsmay differ from actual products. List of specifications is not comprehensive. The logos and visual identity of the company are the property of MANITOU and may not be used without authorisation. All rights reserved. The photos and diagrams contained in thisbrochure are provided for information only.MANITOU BF SA - Limited company with board of directors - Share capital: 39,547,824 euros - 857 802 508 RCS Nantes
MHT 1490on tyres on stabilizers
LiftingMax. capacity at 600 mm LC 9000 kgMax. lifting height 13.65 m 14.00 mMax. outreach 9.55 m 9.45 mUnladen timeLifting 14.9 sLowering 12.8 sExtension 18.9 sRetraction 10.8 sTyres 17.5 R25BrakingParking brake Negative parking brakeEngine Mercedes Stage 4 (Tier IV Final)Type OM 934LACubic capacity 5100 cm3
Power 176 HP/129 kWMax. torque 750 Nm/1200-1600 rpmLaden drawbar pull 10900 daNGradeability (laden) 34%Transmission HydrostaticReversing shift electrohydraulic controlNumber of gears (forward/reverse) 2/2Max. travel speed(may vary according to applicable regulations)
40 kph
Axle DANA
Steering mode 4 wheel steer3 steering modes
Controls JSM® Joystick multi-functionload limiter cut off system - EN 15000 norm
Hydraulics Piston pump LSLoad Sensing Pump 180 l/min - 300 barCapacitiesHydraulic oil 275 lFuel 315 lUnladen weight (with forks) 19500 kgDimensionsC. Front wheel centre to carriage 1.92 mB. Wheelbase 3.37 mI. Rear wheel centre to rear face 1.41 mD. Overall length to carriage 6.71 mG1. Ground clearance 0.44 mJ. Overall width of cab 0.92 mW. Overall width 2.50 mW1. Overall width (stabilizers lowered) 3.03 mU2. Overall height 3.00 mStandard forks(length x width x thickness)
1200 x 200 x 60 mm
Turning radius over tyres (V2) 4.01 mFrame levelling (H1/H) +/- 8°Carriage rotation -crowd/dump (Y/Z) 135°Noise and vibrationNoise at driving position (LpA) 82 dBEnvironmental noise (LwA) 106 dBVibration to whole hand/arm <2.5 m/s2
MHT 1490
mm MHT 1490A 1200B 3370C 1865C1 1795D 6655D1 6585D2 5495F 2065F1 2065G 440G1 440G2 440G3 290H 10H1 10I 1415J 930K 1425
mm MHT 1490L 60O 200P2 18°P3 36°R 3740S 8550T 4540U1 2930U2 3000V 5570V1 1030V2 4015W 2510W1 3030W2 1280W3 2410Y 28°Z 107°
FT095EN_B_1014_MHT1490.indd 2 21/10/14 16:34
FT095EN_B_1014_MHT1490
This brochure describes versions and configuration options for MANITOU products which may be fitted with different equipment. The equipment described in this brochure may be standard, optional or not available depending on version. MANITOU reservesthe right to change the specifications shown and described at any time and without prior warning. The manufacturer is not liable for the specifications given. For more information, contact your MANITOU dealer. Non-contractual document. Product descriptionsmay differ from actual products. List of specifications is not comprehensive. The logos and visual identity of the company are the property of MANITOU and may not be used without authorisation. All rights reserved. The photos and diagrams contained in thisbrochure are provided for information only.MANITOU BF SA - Limited company with board of directors - Share capital: 39,547,824 euros - 857 802 508 RCS Nantes
12
13
1413.67
15
11
10
9
8
7
6
5
4
3
2
1
0
-1
4000
2000
1500
2500
3000
7000
4500
5000
6000
8000
9000
-18910 7 6 5 4 3 2 1 0
9500
12
13
14
15
11
10
9
8
7
6
5
4
3
2
1
0
-1
3500
4000 45
0050
00
6000
7000
7500
8000
8500
9000
-18910 7 6 5 4 3 2 1 0
9411
Machine on stabilizers with forks600 mm CDG Forks
Rough terrain load chartstandard EN1459 B
Machine on tyres with forks600 mm CDG Forks
FT095EN_B_1014_MHT1490.indd 3 21/10/14 16:34
Your nearest MANITOU dealer:
Head office:B.P. 249 - 430 rue de l’Aubinière - 44158 Ancenis Cedex - France
Tel: 00 33 (0)2 40 09 10 11 - Fax: 00 33 (0)2 40 09 10 97www.manitou.com
FT095EN_B_1014_MHT1490
FT095EN_B_1014_MHT1490.indd 4 21/10/14 16:34